Lighting installation for Solar street lamps

- Jun 05, 2017 -

1. The components are fixed: the Sun plate is fixed on the solar panel bracket, the lamp holder is fixed to the picker, then the bracket and the picker are fixed to the main rod, and the connecting line is put into the control box (the Battery box).

2. Before hoisting the lamp rod, check all parts of the fastener is firm, the lamp is properly installed, the light source is working normally. Then in the simple debugging system work is normal; release the controller on the Sun board connection line, the light source works.

3. The main lamp rod hoisting, the attention safety guard; The screw is absolutely fastened well, such as the component Chaoyang angle has the deviation, needs to go up the end adjustment its Chaoyang direction completely Xiangnan.

4. Put the battery into the battery box, connect the connecting line to the controller according to the technical requirement, connect the battery, then connect the load, then connect the Sun board; Wiring operation must pay attention to the wiring and the controller indicated on the wiring terminals can not be wrong, positive and negative polarity can not collide, can not be reversed;

5. Debugging system work is normal; release the controller on the Sun board connection line, light light, connect the Sun board connection line, lights out, and carefully observe the controller on the changes in the lights; All is normal, can seal the control box.

Related Products