Causes of equipment failure or installation problems
The phenomenon of one side of the tunnel light being yellow on the other side is usually caused by equipment failure or installation problems, and is not a normal design. The following is a specific analysis of the reasons:
1. Cause of failure
Circuit or lamp bead failure
Loose bulb socket and poor contact of the grounding wire will cause unstable current and cause abnormal light color.
LED lamp bead series circuit falls off or some lamp beads are damaged, which may cause differences in luminous colors in different areas.
Aging or pollution of lamps
Aging of the lampshade may cause a decrease in light transmittance on one side, indirectly affecting the color performance.
External factors (such as paint covering the light strip during construction) will directly change the color of the light, resulting in uneven yellow and white.
2. Design features of normal tunnel lights
Uniformly use yellow light as the main light source: Sodium lamps (especially high-pressure sodium lamps) are commonly used light sources in tunnels. Their yellow light (wavelength of about 589nm) has strong penetration and can effectively deal with environmental interference such as exhaust gas and dust.
Segmented lighting but consistent color: Different areas such as the tunnel entrance, transition section, and basic section may use different brightness lighting, but the same section usually keeps the light source color temperature consistent.
3. Solution
If the color of the tunnel light is abnormal, it is recommended to:
Check the circuit connection and bulb status, and replace the damaged parts.
Clean the pollutants on the lampshade surface or replace the aging lampshade.
Contact a professional for repair to avoid the risk of self-operation.
Summary: The normal design of the tunnel light will not have the yellow and white edge phenomenon. This problem is mostly caused by equipment failure or external interference, and requires targeted investigation and repair.

